Objective:
This document will guide you through the manual process of restarting the EasyLinx Server. These steps are normally required on specific occasions, suggested to you by the EasyLinx support team.
Procedure:
1. Locate the server installed in your location. It is a black box like the one below:
2. On the back of the unit, find the power cable connected to this port:
3. Disconnect it from the black box (server), wait 15 seconds, and connect it again.
Left black blox
After this procedure, the Server will reboot. It takes a few minutes to get the system running again.
Comments
0 comments
Article is closed for comments.